1. Power off computer. Remove any power cable and VGA cable from back panel of the computer.
2. Connect new hard disk to SATA connector and power connector. Make sure both old and new hard disk is connected to same motherboard and computer.
3. Connect power cable and VGA cable to computer. Boot up computer.
4. Insert Hiren BootCD. Wait it to load.
5. Select DOS BootCD.
6. Select Recovery Tools. Select Symantec Norton Ghost.
7. Click Next and Choose source and destination hard disk for cloning process.
8. Choose Next.
9. Wait until cloning is finish.
10. Click Reset computer for restart.
11. Connect new hard disk to computer to replace old hard disk or remove old hard disk form the computer.
12. Boot up computer and check Windows is fine.
2. Connect new hard disk to SATA connector and power connector. Make sure both old and new hard disk is connected to same motherboard and computer.
3. Connect power cable and VGA cable to computer. Boot up computer.
4. Insert Hiren BootCD. Wait it to load.
5. Select DOS BootCD.
6. Select Recovery Tools. Select Symantec Norton Ghost.
7. Click Next and Choose source and destination hard disk for cloning process.
8. Choose Next.
9. Wait until cloning is finish.
10. Click Reset computer for restart.
11. Connect new hard disk to computer to replace old hard disk or remove old hard disk form the computer.
12. Boot up computer and check Windows is fine.
Comments
Post a Comment